|
 Material Safety Data Sheet
|
U.S. Department of Labor
|
|
May be used to comply with
|
Occupational Safety and Health Administration
|
|
OSHA's Hazard Communication Standard,
|
(Non-Mandatory Form)
|
|
29 CFR 1910.1200. Standard must be
|
Form Approved
|
|
consulted for specific requirements.
|
OMB No. 1218-0072
|
|
IDENTITY (As Used on Label and List)
Petrarch / Fasset Composite Panels
|
Section I
|
Manufacturer's Name
CEP Panels, Ltd. c/o CEP Panels, Inc.
|
Emergency Telephone Number
630-355-4040
|
|
Address (Number, Street, City, State, and ZIP Code)
22 East Chicago Ave.
Suite 210
Naperville, IL 60540
|
Telephone Number for Information
630-355-4040
|
| |
Date Prepared
1/8/04
|
| |
Signature of Preparer (optional)
|
Section II - Hazard Ingredients/Identity Information
|
Hazardous Components (Specific Chemical Identity; Common Name(s))
|
OSHA PEL
|
ACGIH TLV
|
Other Limits
Recommended
|
%(optional)
|
|
Polyester resin, Glass fiber, Slate powder & granules, Calcium carbonate
Small quantities (less than 3%) of some of the following:
Antimony Oxide, brominated fire retardant, titanium dioxide, iron oxide, chromium oxide, carbon black
|
Section III - Physical/Chemical Characteristics
|
Boiling Point
|
N/A
|
Specific Gravity (H2O = 1)
|
2.2
|
|
Vapor Pressure (mm Hg.)
|
N/A
|
Melting Point
|
N/A
|
|
Vapor Density (AIR = 1)
|
N/A
|
Evaporation Rate
(Butyl Acetate = 1)
|
N/A
|
|
Solubility in Water
Insoluble
|
|
Appearance and Odor
Colored Panels with no odor
|
Section IV - Fire and Explosion Hazard Data
|
Flash Point (Method Used)
N/A
|
Flammable Limits
N/A
|
LEL
N/A
|
UEL
N/A
|
|
Extinguishing Media
Dry chemical, carbon dioxide, foam, water
|
|
Special Fire Fighting Procedures
None
|
|
Unusual Fire and Explosion Hazards
None
|
Section V - Reactivity Data
|
Stability
|
Unstable
|
|
Conditions to Avoid
N/A
|
| |
Stable
|
X
|
|
|
Incompatibility (Materials to Avoid)
None
|
|
Hazardous Decomposition or Byproducts
None
|
|
Hazardous
Polymerization
|
May Occur
|
|
Conditions to Avoid
N/A
|
| |
Will Not Occur
|
X
|
|
Section VI - Health Hazard Data
|
Route(s) of Entry:
|
Inhalation?
Yes
|
Skin?
No
|
Ingestion?
No
|
|
Health Hazards (Acute and Chronic)
When cutting or drilling some dust may be generated
|
|
Carcinogenicity:
|
NTP?
No
|
IARC Monographs?
No
|
OSHA Regulated?
No
|
|
Signs and Symptoms of Exposure
Respiratory irritation
|
|
Medical Conditions Generally Aggravated by Exposure
Pre-existing respiratory problems
|
|
Emergency and First Aid Procedures
Remove to fresh air. Seek medical advice if breathing difficulties continue.
|
|
OSHA 174, Sept. 1985
|
Section VII - Precautions for Safe Handling and Use
|
Steps to Be Taken in Case Material is Released or Spilled
Treat as non hazardous material
|
|
Waste Disposal Method
Dispose of as non hazardous material
|
|
Precautions to Be taken in Handling and Storing
Store the panels on a flat surface clear of the ground and under cover.
|
|
Other Precautions
Panels should be carried on edge and never lifted flat unless supported.
|
Section VIII - Control Measures
|
Respiratory Protection (Specify Type)
Use NIOSH (National Institute for Occupational Safety and Health) approved N95 Particulate Respirator for nuisance dust. (Suggested Manufactures: 3M, Gerson, Air Tek, or Equivalent)
|
|
Ventilation
|
Local Exhaust
N/A
|
Special
N/A
|
| |
Mechanical (General)
N/A
|
Other
N/A
|
|
Protective Gloves
None
|
Eye Protection
Wear eye protection when cutting or drilling
|
|
Other Protective Clothing or Equipment
None
|
|
Work/Hygienic Practices
N/A
|
| |
* U.S.G.P.O.: 1986 - 491 - 529/45775
|